The cookie settings on this website are adjusted to allow all cookies so that you have the very best experience. If you continue without changing your cookie settings, we'll assume that you are happy to receive all cookies on our website.         

Services

Chimney sweeping

If you are looking for a chimney sweep you have come to the right place, we are highly experienced, well-equipped chimney sweeps, providing a friendly and efficient service to customers in Market Harborough and the local regions.

Its vitally important to ensure your chimney is swept regularly to avoid the risk of fire, the threat of carbon monoxide poisoning and in fact your house insurance may be void if you don't have your chimney swept.

We employ a strict regime of cleaning our; van, uniforms and equipment. This combined with following best practices during the sweeping, and covering floor surfaces to ensure that we leave your house as absolutely clean as is possible.

Our bookings are handled via our computerised system which enables us to be as prompt as possible to ensure that customers are contacted in unlikely event of a delay.

We serve customers throughout : Leicestershire, Northamptonshire, Rutland, Nottinghamshire, Bedfordshire and Huntingdonshire.

Contact Numbers for Bookings and Enquiries:  01858 419535 /  01858322009      

Website: www.cleansweepharborough.co.uk
 

Installations

It is recommended and advised that Installations are carried out by a Hetas Registered Engineer.

Flexible Flue Liner Installation

Take notice of the direction arrows and UP marking on the seam of the liner. It is important that the liner should be installed so that the arrows point up the chimney. This will allow any condensation to drain downwards over the internal joint.

  1. Attach a nose cone with a draw rope to what will be the bottom end of the liner.
  2. Installation is a job for 2 people.
  3. If the liner is to be insulated with the blanket, fix this to the first section.
  4. 1st installer drops the draw rope down the flue.
  5. 2nd installer takes the rope at the bottom of the chimney and carefully pulls the liner downwards whilst..
  6. The 1st installer guides the liner over the top of the chimney and into the flue, taking care to avoid letting the liner bend too sharply or scrape over any sharp corners.
  7. Once the liner is pulled all the way through the flue, connect the base of the liner to the appropriate adaptor using stainless steel self tapping screws and seal with fire cement.
  8. If granular insulation is to be use, close the bottom of the flue and pour the insulation into the flue from the first of any openings making sure that the liner is held centrally in the void and allowing the insulation to pour all the way round.
  9. Continue this process to the top of the chimney making sure that the void is filled with insulation to the top.
  10. Fit the closure plate and top clamp.
  11. Flaunch with a suitable mortar or fit a suitable chimnen pot.

Twin Wall Flue System

We offer a simple and quick to assemble twin wall insulated flue system suitable for internal and external application, which can be used for solid fuel and woodburners. Our standard twin wall flue range comes complete with all the components that you'll need for your installation.